Need to find a supplier for a drive belt to fit a Montgomery Ward
Power-Kraft 10' Table saw. Model# THS2700. Ser #46X3373. Belt is flat,
11" circumference X 3/4 wide w/47 teeth. -

Hello annapolis, 

I'm reposting this as an 'Answer" per your comment below. Thank you
very much.

The folks at Toolkraft seemed to know the part you are seeking. They
may even be able to provide you with a subsitute similar to the one
you had that broke, if necessary.
 
I have found one supplier, Toolkraft ( http://www.toolkraft.com ), who
says they have this drive belt, however I noticed that their width is
1" rather than the 3/4" that you mention. I am posting their response
to my email as a comment here. But if this is the correct part that
you are seeking, please let me know and I will re-enter my comment as
an 'Answer'.
 
I emailed them asking if they had exactly what you specified and this
was their reply:
 
"Yes, we have the belt in stock. The new # is XM-1118. It is 1" wide.
The price is $15.50 plus $4.50 S&H. Thank you.
 
To buy: Call us with MasterCard or Visa or send a check or money order
to TOOLKRAFT at the address below. (If you send a check be sure to
include the part or model number of your machine.)
 
 
Toolkraft Parts 
3 Craftsman Rd. 
East Windsor, CT. 06088 
Phone: (860) 623-1781 
Fax: (860) 654-1937 
MangariN@aol.com 
 


The search terms I used were:
"drive belt"
"power kraft"
"power craft"
"table saw"

These searches resulted in finding the Toolkraft web site mentioned in
a message board.
 

Regards, 
wellen 
Google Answers Researcher

Answer: Called ToolKraft and they shipped two replacement belts on same day.
Good answer, right on.

Hello annapolis,

I have found one supplier, Toolkraft ( http://www.toolkraft.com ), who
says they have this drive belt, however I noticed that their width is
1" rather than the 3/4" that you mention. I am posting their response
to my email as a comment here. But if this is the correct part that
you are seeking, please let me know and I will re-enter my comment as
an 'Answer'.

I emailed them asking if they had exactly what you specified and this
was their reply:

"Yes, we have the belt in stock. The new # is XM-1118. It is 1" wide.
The price is $15.50 plus $4.50 S&H. Thank you.

To buy: Call us with MasterCard or Visa or send a check or money order
to TOOLKRAFT at the address below. (If you send a check be sure to
include the part or model number of your machine.)


Toolkraft Parts
3 Craftsman Rd.
East Windsor, CT. 06088
Phone: (860) 623-1781
Fax: (860) 654-1937
MangariN@aol.com


Regards,
wellen
Google Answers Researcher

Hello wellen-ga: In response to your comment. The belt that broke was
3/4inches wide, however, after reading your comment I measured the
width of the pully and it was one inch. I suspect that the broken
drive belt was not OE but a narrower belt (3/4) that worked. I am
going to take a chance and  purchase the belt from Toolkraft. If all
the other attributes of drive belt are the same a one inch wide belt
should work. - Post your comment as "Answer".
Thanks a million, Annapolis

If it doesn't work I'll be back.