I am looking for a part number and a place I can purchase from for the following:

The clamps that hold down the plate on a AB Dick 9850, they have
little spikes that stick up in the air on both of them.  They should
not have anythink you have to turn or clamp down.  I need the origonal
or equivlent of, this part for the AB Dick 9850.  Please make sure
they are the origonal and they meed the requirment of having the
spikes / studs as opposed to any sort of clamping contraption.

I also need to replace the gear that allows you to adjust the speed
control on this press.  It is a while ish color gear and it is located
directly above the shaft of the speed control handle.

Thank You!

---

Request for Question Clarification by andrewxmp-ga on 18 Nov 2003 21:30 PST

Hi.

I am in the process of contacting the A.B. Dick service department
about this question.  I hope to ave an answer for you by tomorrow
sometime; hopefully this would be soon enough for you.  Thanks.

-Andrewxmp

---

Clarification of Question by jamiedolan-ga on 18 Nov 2003 22:48 PST

That would be excellent.  Please make sure to include the part numbers
for me.  The source from which I can buy them is not as important.  I
have several people I can order from, however, they are not able to
place the order without the part number.  My press failed to come with
the origonal parts, so I have no idea what the origonal part numers
are.  I just know that we need the bars that will work with standard
punched plates.  THank YOu!

---

Clarification of Question by jamiedolan-ga on 19 Nov 2003 23:10 PST

I will include an addition tip if this question is answered by 1:00 cst on thursday.