Hi, 
Just purchased a Barebone Celeron 2400Mhz U_customize system. It came
with 478 Processor Chip Socket and a M963G ver 3.2 motherboard. The
Manual for this says P4 Motherboard M963 User?s guide.

My question is in relation to page 14. It tells me to install the
Front Panel USB Header to the JUSB1/JUSB2 auxiliary jumpers. My
problem is the markings on the wires do not match the Table given in
the book. The table in the book shows this:

Pin     Signal            Pin        Signal 
1       VERG_FP_USBPWR0   2      VERG_FP_USBPWR0 
3       USB_FP_P0-        4       USB_FP_P1- 
5       USB_FP_P0+        6       USB_FP_P1+ 
7       GROUND            8       GROUND 
9       KEY              10       USB_FP_OC0 

Now there are 8 wires and they show this on them: 

1+5v 
1+D 
1-D 
1GROUND 

2+5v 
2+D 
2-D 
2GROUND 

My question is which wire goes where on the JUSB1/JUSB2 terminals. 

Thank you,
Behzad

---

Request for Question Clarification by endo-ga on 26 Nov 2004 10:51 PST

Hi,

I believe you can only put in the connector in a certain direction
because of the missing pin (looking at the diagram).

Thanks.
endo